Motion control system
Simple Motion Control with Dragonframe (DFMoco)
Overview
This sketch turns an Arduino or equivalent development board into a multi-axis
motion control signal generator. It is for use with the Arc motion control system in
Dragonframe 4. It generates step and direction signals, which can be sent to
stepper motor drivers.
Note: This is NOT a REAL TIME solution.
This is a simple, low cost, motion control solution for stop motion and time-lapse.
Dragonframe will move all of your motors to position for frame 1, then shoot, then
move all of your motors to position for frame 2.
If you need real-time moves you should check out the DMC-16: